Deckel NC Milling Machine Web Site

Web Site updates

Technical site issues and a Forum page

Posted by kattenes on September 18, 2009 at 1:04 PM

Site issues:

 

The web site has some technical issues. Sometimes the side bar will not come up, pages that are deleted are linked where they should not be, the guestbook has entries not visible to my browser, people can see pages that should be invisible.

I blame my site host. "Webs" seems terminally incapable to create a stable system before they change everything and force people to migrate into a new even more unstable format, whereby the migration looses data or creates gost copies of pages, which then pop up later for no reason, long after they are obsolete. I can no longer recommend them.

 

Anyway I have tried to fix stuff, but there are surely some issues left.

 

 

Forum:

 

I have established a Forum page so that people can talk to each other and answers remain visible.

The Forum is here: Forum

 

Note that I have transfered some stuff from the guestbook to the Forum site. I encourage participation.

 

Kattenes

 


Categories: None

Post a Comment

Oops

  • Oops, you forgot something.
Already a member? Sign In

3 Comments

Reply Ron
11:48 AM on December 04, 2009
I have a Deckel FP4NC with a dialog 3 control.This am i was jogging the Y axis and the machine shut down (faulted out).A small V in a luminous field appeared beside the Y axis
read out on the control screen.When i powered up the machine again it simply turns off. I powered it down completley (turn off the disconnect) and when i turned it back on
the Y axis read out was completley gone,I could jog the X & Z axis but the Y axis was not accessable.I then powered it down again for a longer period of time. I have turned it
back on again and the Y axis is back on the screen but still has that V beside it that I mentioned earlier. The machine pwers up but then turns back off again. Does anyone
have any information as to what the problem could be?I suspect a PLC issue what do you think?
Reply kattenes
03:03 PM on December 04, 2009
Put your question in the forum and I'll answer it.

Ron says...
I have a Deckel FP4NC with a dialog 3 control.This am i was jogging the Y axis and the machine shut down (faulted out).A small V in a luminous field appeared beside the Y axis
read out on the control screen.When i powered up the machine again it simply turns off. I powered it down completley (turn off the disconnect) and when i turned it back on
the Y axis read out was completley gone,I could jog the X & Z axis but the Y axis was not accessable.I then powered it down again for a longer period of time. I have turned it
back on again and the Y axis is back on the screen but still has that V beside it that I mentioned earlier. The machine pwers up but then turns back off again. Does anyone
have any information as to what the problem could be?I suspect a PLC issue what do you think?
Reply Harro de Cocq
10:33 AM on May 19, 2010
Does anyone have the schematics of the NSV80 power supply board?
I have a broken down NSV80 I want to (have) repair(ed).

Thanks in advance!!