Deckel NC Milling Machine Web Site

• hamamec commented on his own a profile Feb 15, 2012 
• hamamec commented on a profile Jan 16, 2012 
• hamamec commented on his own a profile Jan 15, 2012 

Post a Comment

2 Comments

Loading...

Reply hamamec

09:10 AM on February 15, 2012 

Hi Bernard. You write that you live nearly next to the factory and have a lot of friends with Dialog skills.
I have a problem with my NSV55. The fuse and BUZ 30A has been replased several times by the previous owner buy no luck so fare.
I am going to change the big capasitors,but other than that I dont have a big plan. I have not got it in my shop yet so a lot of testing
has so fare not been done.
According to info found on this homepage my Dialog 4 should be set up with a NSV56, but mine has a NSV55 installed.
It would be greate to come in contact with you and eaven greater if you could help me in any way.
I have downloaded everything of the ORANGE book stuff,
but part 4 containing component layout and electronics diagrams could not be downloaded for some reason.
In my mind I am thinking:Is this homepage alive anymore?
Best regards hamamec
Harald Madsen aus Norwegen hmadsen@online.no

Reply hamamec

08:18 PM on January 15, 2012 

Just found this web site
I just got my hand on a FP3NC Dialog 4. I have not picked it up yet,but when I get it home I will probably have good use of this web site as it is dead.
I will start with the capasitors.
By the way, it comes with a Deckel Digitizing System the books and the PC cards.